Smart Electronic Keypad Lock for Safe Boxes, 5 User Codes, 0-59 Minutes Time Delay, Dual Control

Changing the Battery: 1. Locate the battery cover on the bottom edge of the keypad and remove the cover by pulling on the tab. 2. Carefully and gently remove the 9-Volt battery from the compartment. Caution: Hold onto the battery connector to avoid pulling the wires out of the housing. 3. Carefully re-insert the new 9V alkaline battery. Do not force the battery into the compartment. 4. The lock will retain all current codes and settings.

Operating Instructions: 1. Install a 9-Volt Battery. 2. Enter the [factory set Code x - x - x - x - x - x - x - x - #]. The green light will turn on. 3. Turn the handle before the green light turns off. 4. To lock your safe, close the door and turn the handle back to the locked position. 5. If your code is correct, a green light will turn on for approximately 5 seconds. If the code is incorrect, a red light will turn on, followed by 5 'Beeps'.

Troubleshooting: 1. The lock has no response [no 'Beeps']: - Make sure the battery wires in the keypad housing are not pinched and are securely connected. - The lock may be in the Lockout Penalty mode. Wait 5 minutes and check if the lock responds [see Wrong Try Penalty]. - Replace the existing battery with a new one [see Changing The Battery]. 2. The lock is responding but does not unlock: - Make sure you are getting a valid response. - Make sure you get a signal with every key-stroke. - Make sure you are not in Time Delay mode [see How to Open In Time Delay Mode]. - Replace the existing battery with a new one [see Changing The Battery].

Low Battery Warning: 1. When you enter your code, a green light and a red light will turn on for 5 seconds, and you will also hear 10 'Beeps'. The safe will probably not unlock when you get this response. 2. When you enter your code, a green light will turn on for 1 second. The safe will not unlock when you get this response.

Time Delay Function: 1. Setting Time Delay [0-59 minute time delay]: - Input: --1-5-9-# [Lock will 'Beep' 2 times] - Input: Current Master Code -# [Lock will 'Beep' 2 times] - Input: 2-# [Light stays green for 3 seconds] (01 = 1 minute Time Delay, 00 = Will turn Time Delay mode off, 59 = 59 minute Time Delay) 2. How to Open in Time Delay Mode: - Enter any valid code other than the Master Code. - Once the code is entered, the Time Delay will activate. - During the Time Delay, codes will not be accepted. When you press any key, the light will remain orange for 3 seconds. - The lock will 'Beep' continuously, and the green light will flash for the last 30 seconds of the Time Delay period. - Once the continuous 'Beeps' stop, the lock will unlock for 5 seconds.

Additional Features: - Time delay can be programmed from 0-59 minutes. - Up to 5 user codes and 1 master code can be programmed and deleted (3-8 digits). - User code + manager code opening or single user code opening can be programmed. - The battery can be replaced easily at the bottom of the keypad frame (1 * 9V lithium cell required). - Low battery warning and wrong code lockout function. - Keypad dimension: 3.74"H * 3.74"W * 1.22"D.

product information: